90 F. 804

UNITED STATES v. H. BOKER & CO.

(Circuit Court, S. D. New York.

December 17, 1898.)

No. 2,459.

Customs Duties — Classification—Steel Strips.

Steel strips flattened from round steel wire, not smaller than 13 wire gauge, and cut into lengths, not valued at above three cents per pound, are dutiable under paragraph 122 of the tariff act of 1894, covering “steel in ail forms' and shapes not specially provided for, * * * valued above two and two-tenths cents and not above three cents per pound,” and not under paragraph 124, as articles manufactured from round steel wire.

This was an appeal by the United States from a decision of the board of general appraisers sustaining the protest of the importers as to the classification of certain imported articles of merchandise.

James T. Van Rensselaer, Asst. U. S. Atty.

Albert Comstock, for importers.

TOWNSEND, District Judge

(orally). The merchandise in question comprises steel strips flattened from round steel wire, not smaller than 13 wire gauge, and cut into lengths. The board of general appraisers, sustaining the claim of the importers, classified the articles for duty, under the provisions of paragraph 122 of the act of 1894, at nine-tenths of one cent per pound for “steel in all forms and shapes not specially provided for in this act, * * * valued above two and two-tenths cents and not above three cents per pound.” The United States appeals from said decision, claiming that these strips are articles manufactured from round steel wire, and therefore dutiable at one and one-quarter cents per pound, and with an additional duty of one- cent per pound, under the provisions of paragraph 124 of said act.

The government relies upon the case of Junge v. Hedden, 146 U. S. 233, 13 Sup. Ct. 88, where dental rubber was held to be an article of rubber. It does not appear, however, that these wire strips come within the reasoning of that decision. The mere flattening of the round wire does not constitute it an article manufactured from wire.

There is considerable force in the further contention of counsel for the importers that congress would not have thus provided that while such steel strips, when valued at over four cents a pound, should pay only a duty of 40 per cent., these strips, coneededly not worth more than three cents per pound, should thus pay from 75 to 100 per cent, of duty. The decision of the board of general appraisers is affirmed.

United States v. Boker
90 F. 804

Case Details

Name
United States v. Boker
Decision Date
Dec 17, 1898
Citations

90 F. 804

Jurisdiction
United States

References

Referencing

Nothing yet... Still searching!

Referenced By

Nothing yet... Still searching!